Home > News > Content

Lawn mower

- May 24, 2018 -


Lawn mower, consists of a cutter head, an engine, a walking wheel, a walking mechanism, a blade, an armrest and a control part. It consists of a parallel four bar lifting device, a rack, a left and right single wing hoe device, a whole machine adjustment device, a comb gear speed increase drive mechanism and a comb like depth adjusting device; the efficiency is 8 to 10 times higher than the artificial hoe, and the rate of injured seedlings is low, and the cleaning rate of the seedlings is high.


1. Before mowing a lawn mower, it is necessary to remove the litter in the mowing area so as not to damage the straw and blade. When starting the engine in the cold state, the air door should be closed first, and then the air door will be opened in time. If the turf area is too large, it is best not to exceed 4 hours.

2. After the lawn mower is used, it should be thoroughly cleaned, check all the screws fastened, the blade have no defect, overhaul the high pressure cap and so on. It should also be checked or replaced according to the life of the mower.



1. Maintenance of oil

Every time you use the mower, check the oil level to see if it is between the upper and lower scales of the oil gauge. The new engine should be replaced after 5 hours. After 10 hours, the engine oil should be replaced again. The oil will be changed regularly according to the instructions. The engine oil should be carried out under the heat engine condition. Oil can not be overloaded, otherwise it will appear: black smoke, lack of power (cylinder carbon deposition, spark plug clearance is small). Engine overheating. The injection oil can not be too small, otherwise it will be now: engine gear noise, piston ring accelerated wear and damage, and even now pull the phenomenon, causing serious damage to the engine.

2. The maintenance of air filters should be checked every time before and after use. If it is too dirty, it will cause engine difficult to start, big black smoke and insufficient power. If the filter core is paper, it can unload the filter core and dust the dust attached to it. If the filter core is cavernous, the filter core can be dripped with some lubricating oil to keep the filter core moist, and it is more conducive to the adsorption of dust.

Related Industry Knowledge

Related Products

  • Smarter Tools 1000 Watt Inverter Generator
  • Lightweight Electric Chainsaw
  • Power Inverter Generator 1000w
  • 1,000-Watt Gasoline Powered Inverter Generator
  • Professional Chain Saw,Petrol Chainsaw
  • Most Powerful Electric Chainsaws